Node-Red is a popular logic / event management software, which can be used in EVA ICS together with Logic Manager or replace it.

EVA ICS and Node-Red are perfectly compatible. The primary recommended channel for data communication is MQTT server, while EVA ICS units can be controlled either via MQTT or with JSON RPC API (third-party Node-Red component required:

This example is considered to be correct for the EVA ICS instance / cloud, containing at least one MQTT notifier.


In production environments, it is highly recommended to extend Node-Red with third-party custom components, which should provide access control and action logging.

Configuring EVA ICS

Create a virtual sensor and a virtual unit:

# create a sensor, no virtual driver required
eva uc create sensor:tests/temp -yE
# load a virtual relay driver for units
eva uc phi load vr1 vrtrelay -y
# create a unit
eva uc create unit:tests/vent -yE
# assign the virtual driver to the unit
eva uc driver assign unit:tests/vent vr1.default -c port=1 -y
# allow controlling the unit via MQTT
eva uc config set unit:tests/vent mqtt_control eva_1:2 -y

Collecting events in Node-Red

Let us collect events from sensor:tests/temp via MQTT. Drop “mqtt in” component on the flow dashboard:


If there is no MQTT server configured yet in Node-Red, press “edit” button and define a new one:

../../_images/mqtt-server-setup-1.png ../../_images/mqtt-server-setup-2.png

Set MQTT topic, note that “:” in EVA ICS item oid should be replaced with “/”. Set output to “a parsed JSON object”:


Processing events

Put a processing component on the flow, e.g. a switch, and connect the node with MQTT input:


Let us configure the switch to flow the output one if the sensor value is above or equal 25 and the output two otherwise.

The serialized sensor MQTT event, sent by Universal Controller, looks like:

    "c": "uc/lab-ws2",
    "status": 1,
    "t": 1611264802.9571016,
    "value": "25"


  • Set the Property to “payload.value”

  • Set condition value type to “number” to parse sensor value as float:


Defining control templates

The next step is to define a control template. Drop “template” component on the flow dashboard:


Edit the template node. Let us use the template to turn a unit on by sending an action to set its status to “1”:

  • Set name to “ON”

  • Set “Output as” to “parsed JSON”

  • Put { “status”: 1 } JSON into the template body


Repeat the same for “OFF” (status=0) action.

Controlling equipment


In production environments it is better to use JSON RPC calls to control units, as MQTT actions do not provide any result / feedback.

Put “mqtt out” component on the flow:


Edit the node, set MQTT topic to “unit/tests/vent/control” (note that “:” should be replaced to “/” as well and the “/control” suffix is added):



Make sure all the flow nodes are connected and press “Deploy” button. Node-Red flow is ready to process events.